Skip to content

Installation

Automatic installation (FMX and VCL only)

Unzip the distribution file TMSFNCAppToolsSetup.zip into a separate directory, further referred to as {$TMSDIR}

Run the setup executable file and install the components for the correct environment. If the setup for FMX or VCL fails follow the manual installation instructions below.

Manual installation

FMXLinux (tested in Ubuntu 20.04)

FMXLinux is not installed out of the box in RAD Studio. Please follow the instructions here to install FMXLinux.

After following the above instructions, please execute the following commands

sudo apt install joe wget p7zip-full curl openssh-server build-essential zlib1g-dev libcurl4-gnutls-dev libncurses5
sudo apt-get install zlib1g-dev
sudo apt install libgl1-mesa-glx libglu1-mesa libgtk-3-common libgstreamer1.0-0 libgstreamer-plugins-base1.0-0
sudo apt install libwebkit2gtk-4.0-dev

For Delphi 10 Seattle, 10.1 Berlin, 10.2 Tokyo, 10.3 Rio, 10.4 Sydney, 11, 12

In the IDE, select File, Open and browse for FMXTMSFNCAppToolsPkgD*.dproj From the project manager, right click on the FMXTMSFNCAppToolsPkgD*.dproj project and from the menu, choose install

In the IDE, select File, Open and browse for VCLTMSFNCAppToolsPkgD*.dproj From the project manager, right click on the VCLTMSFNCAppToolsPkgD*.dproj project and from the menu, choose install

In the IDE, select File, Open and browse for TMSFNCAppToolsPkgDED*.dproj From the project manager, right click on the TMSFNCAppToolsPkgDED*.dproj project and from the menu, choose install

(* XE9, XE10, XE11, XE12, XE13, XE14, XE15)